https://mega.nz/#!ERwlzKpI!ZbHfqyer9Nk8i6C0cdN-PhDCmeKX6odnOX49qQiB8HE
Without help documents.
This version is Internet safe too
works with win10.
Here you have full ksuite, with helps and internet protected, tested by many users. Even winols 2.24 here if you need:
https://mega.nz/#!PoIm1DJL!G7m_TsNs8dMIiI1EmVc46uqHyFu7yFFcMKen37666qA
One setup only needed for both tools, kess and Ktag
I can install it on C partion on SSD Disk also
The above mega links are compatible with the reworked Kess 5.017 china red PCB and KTAG 7.020 china red PCB (Skip to the last paragraph for the pictures).
If you were confused if you have to use an other Ksuite Setup to install the software or use the China Software I became with the tools before the rework? Then I tell you: it doesn't matter, EU clone or China clone using the same SW. If you install SW which you used before reworking, you will have ksuite 2.13 software just. Install 2.23 without any doubt. Reworked tools can work with an old sw, and with a new one 2.23.
Attach Kess 5.017 (china red PCB) picture:
Attach KTAG 7.020 (China red PCB) picture:
.jpg)
No comments:
Post a Comment